ZF 5HP30 Repair Manual
$20ftp download
$40shipping

ZF 5HP30 Repair Manual

ZF 5HP30 Service Manual, Repair Manual, Automatic Transmission ZF.

Technical information:

media OS region language release
1 CD Win 2000, Win 98, Win XP All regions English, German 01 / 2002
Photo preview:

Description:

ZF 5HP30 Service Manual, Repair Manual, Automatic Transmission ZF.

ZF 5HP30 Dealer Service Manual ZF.

This manual covers the procedure for repairing the complete transmission.

The repairing of this transmission is only allowed to persons with specific training from ZF Getriebe GmbH.

The entire disassembly and assembly procedure is described in chronological order.

The photographs were kept general in nature so that they can be used with various applications;

they are not binding in every case.

We use Service Bulletins and training to announce important information and

application-specific changes that must be taken into consideration in maintenance work.

If this repair manual is given to a third party, there will be no modification service.

The Service Bulletins regulations and specifications must be followed when making repairs.

Depending on the type of damage that has occured, the repair work can be limited to that which is

necessary to repair the damage.

In this case you must observe the following:

• Seals (such as O-rings, shaft seals, gaskets, and filters) must always renewed.

• All O-rings, rectangular-section rings, and other sealing rings must always be lubricated

with petroleum jelly before installation.

• All bearings must always be oiled lightly when installed.

• For transmissions that have covered a large number of kilometers (> 80,000 km), all lined

clutch discs and steel clutch discs must be replaced.

• After clutches/ brakes have been damaged, the converter, oil tubes, and oil cooler, must be

cleaned thoroughly with a suitable cleaning agent.

• If brakes C or D has been damaged, or if a considerable distance has been covered (>

80,000 km), pistons C and D must be replaced.

The following requirements should be met before the repair work is started:

• The required special tools should be available.

(The complete set of special tools is listed in Chapter 1.7)

• A suitable transmission testing rig should be available.

The required testing values can be found in the Service Bulletins.